2025.4.0
Home ▸ Integrations ▸

Bosch Alarm

The Bosch Alarm Panel integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] allows you to connect your Bosch Alarm Panel to Home Assistant to control and monitor your Bosch Alarm Panel.

Configuration

To add the Bosch Alarm integration to your Home Assistant instance, use this My button:

Manual configuration steps

If the above My button doesn’t work, you can also perform the following steps manually:

  • Browse to your Home Assistant instance.

  • Go to Settings > Devices & Services.

  • In the bottom right corner, select the Add Integration button.

  • From the list, select Bosch Alarm.

  • Follow the instructions on screen to complete the setup.

Supported devices

  • Solution 2000/3000/4000
  • B Series: B3512/B4512/B5512/B6512
  • G Series: B8512G/B9512G
  • AMAX 2100/3000/4000
  • D7412GV4/D9412GV4 1

Provided entities

The following entitiesAn entity represents a sensor, actor, or function in Home Assistant. Entities are used to monitor physical properties or to control other entities. An entity is usually part of a device or a service. [Learn more] are provided:

Alarm Control Panel

This integration adds an Alarm Control Panel device for each configured area, with the ability to issue arm/disarm commands. This entity reports state (disarmed, armed_away, etc.).

Authentication

The primary means of authentication for the Mode 2 API is the Automation passcode. It needs to be at least 10 characters long, and it is different from the User code – a shorter numeric pin used to arm/disarm the panel. The integration will prompt for the required passcodes, which depend on the panel type.

Panel Code
Solution User 2
B Series Automation
G Series Automation
AMAX Both

Important

Since the Mode 2 automation user has “superuser” privileges, it bypasses the regularly configured alarm pin: you will not be prompted for a User code when arming/disarming through the integration.

Removing the integration

This integration follows standard integration removal. No extra steps are required.

To remove an integration instance from Home Assistant

  1. Go to Settings > Devices & services and select the integration card.
  2. From the list of devices, select the integration instance you want to remove.
  3. Next to the entry, select the three-dot menu. Then, select Delete.

  1. Firmware 2.0+ ↩

  2. The user needs to have the “master code functions” authority if you wish to interact with history events. ↩