FAA Delays

The FAA Delays integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] collects and displays information about delays at US Airports based on the FAA’s National Airspace System Status.

Data measured includes:

  • Ground Delays
  • Ground Stops
  • Arrival/Departure Delays
  • Closures

Configuration

To add the FAA Delays integration to your Home Assistant instance, use this My button:

Manual configuration steps

If the above My button doesn’t work, you can also perform the following steps manually:

  • Browse to your Home Assistant instance.

  • Go to Settings > Devices & Services.

  • In the bottom right corner, select the Add Integration button.

  • From the list, select FAA Delays.

  • Follow the instructions on screen to complete the setup.

Supported airports

The airport entered must be a valid IATA airport code for an airport in the US. You can find this by looking up the FAA Identifier at Airnav.

Additional delay information

Each airport added will expose 5 binary sensors, one for each type of delay. Within each sensor there is additional information listed as attributes, which depends on the type of delay it is. Each delay type has the attributes listed below:

  • Ground Delay
    • Average Delay Time
    • Delay reason
  • Ground Stop
    • Expected End Time for stop
    • Delay reason
  • Arrival/Departure Delay
    • Minimum delay time
    • Maximum delay time
    • Delay trend (increasing/decreasing)
    • Delay reason
  • Closure
    • Start of closure (begin)
    • End of closure (end)