iNELS
The iNELS integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] allows you to control and monitor the devices connected to your control units (BUS or eLAN).
There is currently support for the following device types within Home Assistant:
- Switch
Prerequisites
- MQTT broker.
- eLAN devices flashed with version
mqtt_1.0or later. - BUS devices flashed with version
mqtt_1.0or later. - See the Wiki page for instructions on how to configure the control units.
Configuration
To add the iNELS hub to your Home Assistant instance, use this My button:
iNELS can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.
Manual configuration steps
If it wasn’t discovered automatically, don’t worry! You can set up a manual integration entry:
-
Browse to your Home Assistant instance.
-
In the bottom right corner, select the
Add Integration button. -
From the list, select iNELS.
-
Follow the instructions on screen to complete the setup.
Removing the integration
This integration follows standard integration removal.
To remove an integration instance from Home Assistant
- Go to Settings > Devices & services and select the integration card.
- Next to the entry you want to remove, select the three dots
menu. Then, select Delete. - Depending on the integration, the entries are listed under one of the following headings:
- Devices
- Hubs
- Services
- Integration entries
- Depending on the integration, the entries are listed under one of the following headings:
- To confirm, select Delete.
- Home Assistant also deletes the devices and entities of the entry.
- If Home Assistant asks you to restart, restart Home Assistant.
- If Home Assistant asks whether to also delete the application credentials, select Remove or Keep.
- If you keep them, Home Assistant uses them automatically when you add the integration again.
- To delete them later, refer to Deleting application credentials.
To remove a setting from eLANRF
- Launch the IDM application.
- Select Configuration of the central unit from the menu.
- Select MQTT settings then choose Not Connect in the mode options and click Save to CU.
To remove a setting from CU3
- Open the eLANRF web interface.
- Go to Settings and disable MQTT under MQTT connection.