2026.8.0
Home ▸ Integrations

Lyngdorf

The Lyngdorf integrationIntegrations connect and integrate Home Assistant with your devices, services, and more. [Learn more] allows you to control Lyngdorf audio processors and amplifiers from Home Assistant. Lyngdorf Audio is known for their RoomPerfect room correction technology. This integration lets you control power, volume, source selection, sound modes, and audio processing parameters.

Supported devices

Note

The MP-60 is the only model that has been tested in the wild so far. Other models should work but may not support all features. If you have a different model, please report any issues on GitHub.

Prerequisites

  • Your Lyngdorf device must be connected to the same network as Home Assistant.

Configuration

To add the Lyngdorf device to your Home Assistant instance, use this My button:

Lyngdorf can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.

Manual configuration steps

If it wasn’t discovered automatically, don’t worry! You can set up a manual integration entry:

  • Browse to your Home Assistant instance.

  • Go to Settings > Devices & services.

  • In the bottom right corner, select the Add Integration button.

  • From the list, select Lyngdorf.

  • Follow the instructions on screen to complete the setup.

Host

The hostname or IP address of your Lyngdorf device.

Supported functionality

Media players

The integration creates two media player entitiesAn entity represents a sensor, actor, or function in Home Assistant. Entities are used to monitor physical properties or to control other entities. An entity is usually part of a device or a service. [Learn more]:

  • Main zone: Controls your Lyngdorf device, including power, volume, mute, source selection, and sound mode.
  • Zone B: Controls the Zone B output, including power, volume, mute, and source selection.

Data updates

The Lyngdorf integration uses local push to receive real-time updates from the device over a TCP connection. State changes on the device are pushed to Home Assistant immediately.

Known limitations

  • Only the MP-60 has been tested. Other models may not support all features.
  • Only local network control is supported.

Troubleshooting

Device not discovered

Symptom: Device is not automatically discovered

The Lyngdorf device does not show up as a discovered device in Home Assistant.

Resolution

To resolve this issue, try the following steps:

  1. Make sure your Lyngdorf device is powered on and connected to the same network as Home Assistant.
  2. Check that UPnP/SSDP is not blocked on your network.
  3. Add the device manually using its IP address.

Connection issues

Symptom: Device shows as unavailable

The integration shows as unavailable or disconnects frequently.

Resolution

To resolve this issue, try the following steps:

  1. Ensure your Lyngdorf device has a static IP address or DHCP reservation.
  2. Check your network for stability issues.
  3. Verify that no firewall rules are blocking TCP communication between Home Assistant and your device.

Removing the integration

This integration follows standard integration removal.

To remove an integration instance from Home Assistant

  1. Go to Settings > Devices & services and select the integration card.
  2. From the list of devices, select the integration instance you want to remove.
  3. Next to the entry, select the three dots menu. Then, select Delete.