QNAP QSW

This integration interacts with the local API of QNAP QSW managed switches.

Configuration

To add the QNAP QSW integration to your Home Assistant instance, use this My button:

QNAP QSW can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.

Manual configuration steps

If it wasn’t discovered automatically, don’t worry! You can set up a manual integration entry:

  • Browse to your Home Assistant instance.

  • Go to Settings > Devices & Services.

  • In the bottom right corner, select the Add Integration button.

  • From the list, select QNAP QSW.

  • Follow the instructions on screen to complete the setup.

URL

Device URL (usually http://IP)

Username

Username (usually admin)

Password

Password

Binary sensors

The following binary sensors are created:

Binary sensor Description
anomaly Device anomaly.

The following binary sensors are created for each port (or LACP):

Binary sensor Description
link Link status.

Buttons

The following buttons are created:

Button Description
reboot Reboot device.

Sensors

The following sensors are created:

Sensors Description
fan_1_speed Fan 1 Speed.
fan_2_speed Fan 2 Speed.
ports Number of used ports.
rx Total RX bytes.
rx_errors Total number of RX errors.
rx_speed Total RX speed.
temperature Switch temperature.
tx Total TX bytes.
tx_speed Total TX speed.
uptime Uptime seconds.

The following sensors are created for each port (or LACP):

Sensors Description
link_speed Link speed.
rx RX bytes.
rx_errors Number of RX errors.
rx_speed RX speed.
tx TX bytes.
tx_speed TX speed.

Update

Update Description
firmware_update Firmware update status.